Specifications Condition Pre-Owned 556o FCC ID ELVAT5C Interchangeable FCC IDs BGAAPS2T ELVAT5C Part BAOE2BT Interchangeable Part s: BAOE2BT APS95BT2 BA0E2BT Interchangeable circuit board AT0K AT4B Dealer part Buttons 2: buttons; LED Red Frequency 302 - 309 MHz Battery Type 1: GP23A Additional Information Condition Explanation: Pre-Owned Pre-Owned: An item that has been used previously.The item may have some signs of cosmetic wear, but is fully operational and functions as intended.
Prestige Elvat5C Download Prestige PR1View and Download Prestige PR1-DO instructions for use manual online.Scroll through listing for full details and description of any imperfections. PROGRAMMING: Programming Instructions: It is important to remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically exit program mode. ![]() ![]() Flip the valet switch on - off - on - off - on - then off. The dash LED will flash once, and the siren will chirp once, indicating the system is ready to accept programming for channel 1 or the arm disarm and panic functions. You can assign any of the three transmitter button functions listed below to channel 1 a. Pressing both buttons simultaneously on the keychain transmitter. Press and hold the selected choice a, b, or c above, until the siren emits a long chirp to confirm that programming of channel 1 was successful. The dash mounted LED will flash 2 times, and the siren will chirp indicating that the system is ready to accept programming for channel 2, or the pulsed ground output for remote trunk release, remote car starter, etc. You can assign any one of the two remaining button functions listed in 4a, 4b, or 4c above to operate channel 2. You cannot use the button(s) that operate channel 1, selected in step 5, to operate channel 2. ![]() Move the valetbypass switch on, then off again. The dash mounted LED will flash 3 times, and the siren will chirp indicating that the system is ready to accept programming for channel 3. APS 350) 12. Press and hold the remaining transmitter button function. The siren will emit a long chirp to confirm that programming of channel 3 was successful. To exit program mode, either turn the ignition key to the off position, or move the valet switch on then off one additional time. This is indicated by one short chirp then one long chirp from the siren. NOTE: If programming to a Keyless Entry (non alarm) unit, there will be NO chirp indication. QUICK REFERENCE You can program any individual channel, without reprogramming all channels, by following the quick reference chart below.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |